| |
Damplifier
|
|
Damplifier is the Second Skin entry level vibration mat, but don't let the words "entry level" deceive you. Damplifier is at least 65 mils thick has a mil 3 foil heat shield. Because Damplifier is built according to military specifications. It has a heat tolerance higher than any extreme level mat on the market, over 450 degrees!
Damplifier delivers 250% better vibration damping results than traditional mastic and asphalt mats and close to 300% increase in airborne sound reduction. Damplifier is highly flexible and can be applied to any part of the vehicle. Unlike many other entry level products, Damplifier requires no heat and very little prep work. Simply peel the paper and stick Damplifier on any vibrating panels.
Good for road, engine, and exhaust noise as well as thermal insulation and proving the SPL and sound quality of your cars audio stem. Get louder, cleaner volume and save money while doing it!
|
Use On:
Doors, Rear Shelf & Boot, Roof, Floor, Trim Panels, Wheel Wells, Quarter Panels, Firewall, Bonnet
Adheres To:
 |
Painted or Primed Sheet Metal |
|
Plastic |
|
Existing OEM Sound Deadener |
|
Damplifier™ |
|
Spectrum™ |
|
Specs:
| Thickness |
65 mils |
(.065 in; 1.65 mm) |
| Mass/Area |
.42 lbs/Sq.Ft. |
(2.05 kg/m˛) |
| Heat Tolerance |
475 °F |
(246 °C) |
| Sheets |
12inX24in |
(31.75cmX60.96cm) |
|
Damplifier Pro
|
|
Designed for car modifiers, and car audio competitors, Damplifier Pro was overbuilt to over perform in extremely harsh automotive conditions. Damplifier Pro is at least 80 mils thick and has a foil heat shield 4 mils thick for better vibration reduction and thermal insulation.
Damplifier Pro has a heat tolerance over 500 degrees and can be applied to any area of the car to prevent vibrations and rattles as well as road, engine, exhaust, and wind noise. Damplifier Pro requires no heat and very little prep work. Simply peel the paper and stick Damplifier Pro on any area of the car that needs to be acoustically or thermally controlled.
|
Use On:
Doors, Rear Shelf & Boot, Roof, Floor, Trim Panels, Wheel Wells, Quarter Panels, Firewall, Bonnet
Adheres To:
|
Painted or Primed Sheet Metal |
|
Plastic |
|
Existing OEM Sound Deadener |
|
Damplifier™ |
|
Spectrum™ |
|
Specs:
| Thickness |
80 mils |
(.08 in; 2.03 mm) |
| Mass/Area |
.5 lbs/Sq.Ft. |
(2.44 kg/m˛) |
| Heat Tolerance |
500 °F |
(260 °C) |
| Sheets |
18inX32in |
(45.72cmX81.28cm) |
|
|
|
